CAMPAGNOLA POWER 58 Livret D'utilisation Et D'entretien page 99

NOTE: The grease specified above must be used for all maintenance activities relating to the greasing of mechanical
parts in all disassembly/assembly and/or adjustment activities covered by the maintenance activity.
While the product is in use, the lubricating grease spray indicated below must be used, which is prescribed by the
manufacturer and can be purchased separately.
Supplier
Type
Use
Characteristics of the adhesive/sealant used
The sealant data sheets in this section only contain the main technical characteristics required for purchase, but not
the safety information related to its use.
Before use, request the 'product safety data sheet' from the manufacturer, which can also normally be found on the
supplier's website.
The manufacturer prescribes the use of LOCTITE adhesive/sealant. The adhesive enables maintenance personnel to
prevent persistent equipment failures that cause unscheduled downtime. For further technical details see the Loctite
data sheet available on the supplier's website.
The manufacturer prescribes the use of '
screws and/or bolts to prevent loosening due to vibration.
Excellent on any metal, including passive materials (e.g. stainless steel, aluminium, galvanised surfaces). It can be
disassembled by heating up to 300°C.
The manufacturer prescribes the use of "
locking and/or sealing of threaded fasteners requiring normal disassembly with standard hand tools.
Excellent on any metal, including passive materials (e.g. stainless steel, aluminium, galvanised surfaces). It can be
disassembled by heating up to 250°C.
7.4 STORING THE TOOL
Before storing the tool for a long period, it is advisable to:
•
Clean and grease the head (2) at a Service Centre Authorised by the Manufacturer.
•
Do not leave the tool in the rain when idle. Put it back in its packaging and store it in a dry place.
8. TROUBLESHOOTING
Troubleshooting can only be carried out by trained personnel who have understood the instructions in this manual and
the accompanying documentation.
Situations that can lead to a failure are normally attributable to a lack of or poor maintenance or a failure of some
mechanical and/or electrical/electronic component of the tool or a situation related to the product being handled.
The following table lists possible faults that can occur on the tool. The "Cause" column shows the cause of the fault
condition.
The "Solution" column shows the corrective action to resolve the fault situation that has occurred.
The manual and/or documentation of the component/equipment must be consulted for a diagnosis of the problems with
the trade equipment supplied.
FAULT
The tool does not
work.
The tool does not have
adequate power
Temporary stop of the
tool during use
98
Grease commercial data
PAKELO MOTOR OIL Srl
CAMPAGNOLA LUBE SPRAY GREASE
Multifunctional lithium spray grease with high lubricating capacity, particularly
suitable for electromechanical equipment.
LOCTITE® 270™
LOCTITE® 243™
CAUSE
a) ON/OFF switch in OFF position.
b) Battery pack discharged.
c) Battery connector not inserted
d) Damaged connector
a) Battery pack discharged.
a) Motor overheating due to thick
vegetation.
b) Max current threshold exceeded
': high-strength threadlocker formulated to lock and seal
": a medium-strength threadlocker designed for the
a) Move the switch to the ON position.
b) Recharge the battery.
c) Insert the connector
d) Contact a CAT
a) Recharge the battery.
a) Exit from the vegetation, wait for the
automatic release and restart.
REMEDY
0310.0329 rev. 05