CAMPAGNOLA POWER 58 Livret D'utilisation Et D'entretien page 73

Keep an adequate distance from the working area and cordon off the working area if there is a risk that third parties
may come into contact with the shaking area.
In order to limit risks in danger zones, appropriate prevention and protection measures were taken. Observe the
instructions, both procedural and relating to 'Personal Protective Equipment', given in this manual.
4.7 ENVIRONMENTAL OPERATING CONDITIONS
The environment in which the product is installed is an outdoor environment protected against aggressive agents
such as corrosive vapours or sources of excessive heat.
Unless otherwise specified, the product is intended for use under the following environmental conditions:
➢ Below 1000m above sea level.
➢ Ambient temperature between 5°C and + 45°C. (24-hour average <= at 35°C)
➢ Relative humidity 30% to 85% without condensation.
➢ Material temperature, where applicable < 45° C.
The use of the product and control systems under conditions other than those listed is not permitted.
In particular, the environment of installation and use must not feature:
Exposure to corrosive fumes;
•
Exposure to excessive humidity (above 80 %) and rapid changes in relative humidity (above 0.005 p.u./h);
•
Exposure to excessive dust;
•
Exposure to abrasive dust;
•
Exposure to oily vapours;
•
Exposure to explosive dust or gas mixtures;
•
Exposure to salty air;
•
Exposure to vibration, impacts or abnormal shocks,
•
Exposure to weather outside permitted limits or dripping;
•
Exposure to high or rapid temperature variations (greater than 5K/h)
•
Presence of nuclear radiation
•
NOTE: For products with a battery, please also refer to the battery requirements in the battery documentation
4.8 VIBRATIONS
The product has been designed and constructed in such a way that risks from vibrations transmitted by the product
have been reduced to a minimum.
The vibrations produced by this product, depending on how it is used, in accordance with the information provided
and in compliance with current regulations, are not hazardous to the health of the operator.
Vibration level values expressed in m/s² are given in paragraph 2.2 in the technical data section of this manual.
CAUTION
Excessive vibration can only be caused by a mechanical fault, which means that the product must not be
used and must be reported and rectified immediately, so as not to jeopardise the safety of the product and
the personnel responsible for its operation and maintenance.
4.9 NOISE
Noise measurements were carried out in accordance with EN ISO 3744 acoustics and related standards.
The product does not have sound protection.
Sound power level values expressed in dB(A) are given in the technical data section of this manual.
The use of sound absorbing personal protective equipment (ear muffs) is prescribed for personnel who are in the
vicinity of the product or during maintenance activities with it running.
It is the user's responsibility to take the relevant preventive and protective measures in accordance with the
legislation of the country in which the product is used.
72 0310.0329 rev. 05