Frigomat TWIN 4 S.03 Manuel D'instruction Et De Maintenance page 78

Fig.1
Fig.2
Fig.3
15 - ENGLISH
TAP ASSEMBLY
- Insert the O-ring gasket into the plastic
bottom and lubricate it using the Frigomat
lubricant supplied.
- Insert the piston into the bottom as
illustrated in the figure.
- Position the piston knob onto the rod and
tighten the steel pin. Check that the piston
runs easily in the seat (fig. 1).
- Assemble the O-rings or all tap components
and lubricate them using the Frigomat
lubricant supplied.
- Insert the piston in the machine tap duct
and turn the bottom by a few degrees up to
the block position (fig. 2).
- Insert the tap body and turn it to the vertical
position.
- Insert the locking pin (fig. 3).