Frigomat TWIN 4 S.03 Manuel D'instruction Et De Maintenance page 109

REMOVING AND CLEANING BEATER
• Turn the beater a few degrees anti-clockwise by
hand until the release position and then pull it
upwards. Remove the O-ring remaining on the
transmission shaft of the heater vessel.
• Remove the scrapers, the thrust springs and pull the
bottom bushing downwards.
• Place the previously disassembled components into
the tub with the sanitizer and brush the surfaces with
care. Pay particular attention to the scrapers.
REMOVING AND CLEANING THE TAP
• Remove the locking pin.
• Pull the tap body towards you and pull is completely
off the piping. Remove the sealing O-rings.
ENGLISH - 46