Frigomat TWIN 4 S.03 Manuel D'instruction Et De Maintenance page 170

45 - FRANÇAIS
• Pour the maximum admitted load of cold drinking
water into the tub to rinse the surfaces which were
just treated with the sanitizer.
• Drain the rinse water and turn the machine off.
• When pre-washing is over, all the removable parts in
contact with the product must be disassembled and
sanitized in a separate tub.
SANITIZING REMOVABLE PARTS
PREPARATION OF WASHING TUB
• Wash your hands well and/or wear disposable
gloves.
• Fill a clean tub with a sufficient amount of drinking
water at approximately 50°C and the sanitizer.
• Prepare the supplied brush and the OR disassembly
We suggest using the following sanitising
solution:
Ecolab P3 Topax-san
(4% dilution = 200 ml every 5 litres of water).
device and immerse them in the solution.
REMOVING AND CLEANING COVER
• Pull the hinge pins off and remove the cover, holding
it with both hands.
• Emerge the previously disassembled components
into the tub with the sanitizer and brush the surfaces
with care. Pay special attention to the surfaces in
direct contact with the product.