Low Flame Adjustment; Adjustment For Burners With One Or Two Flame Rings - Fulgor Milano SOFIA FSRC 4807 2P MK 2F Serie Manuel D'instructions

Low Flame Adjustment

DANGER
Lighting gas burners with a match is dangerous.
You should match light the burners only in an
emergency.
Light a match and hold the flame near the burner you
want to light. Wooden matches work best.
Push in and turn the control knob slowly.
Be sure you are turning the correct knob for the burner
you are lighting.
NOTE: If the burner does not light within five seconds,
turn the knob off and wait one minute before trying
again.
CAUTION
If you attempt to measure the inner cone of the flame,
please use caution. Burns could result.
A - SIMMER
B - MAIN FLAME
8 - Conversion to a Different Type of Gas
LOW FLAME ADJUSTMENT
C - GRIDDLE FLAME
This appliance is shipped from the factory with low and
medium flame settings adjusted.
If further adjustment is necessary, proceed as follows:
Adjustment for Burners with one or
two flame rings:
1. Light burner and set control knob for low flame.
2. Remove control knob from valve stem.
3. Remove knob seat from control panel.
4. Insert a slender, thin-blade screwdriver into the recess
behind the control knob (A or B) and engage blade with
slot in adjusting screw.
5. Turn adjusting screw to set flame size:
• clockwise to reduce
• counterclockwise to increase
6. Replace control knob when adjustment is completed.
EN
25