Fulgor Milano SOFIA FSRC 4807 2P MK 2F Serie Manuel D'instructions page 133

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Electric gas ignition
The griddle burner uses an electric ignition device located
near burner that ensures burner ignition. It is thermostatically
controlled to maintain a consistent temperature.
To prevent food from sticking, it is necessary to "season" the
griddle prior to use.
ELECTRIC IGNITION
(A)
IGNITION
(B)
*THERMOCOUPLE
*NOTE: this feature is intended as a safety device.
To set:
• Push the knob, the spark plugs will generate a clicking
sound (spark) for about 10 seconds, turn the knob counter
clockwise to maximum setting, an electromechanical
valve opens in the system to start the gas valve. the burner
will produce a flame.
• The griddle has a power "ON" light which glows when
the griddle thermostat is turned on.
• If the burner fails to light, turn the control knob to the "Off"
position. Air the room or wait at least 1 minute before
trying again.
30 - Gas Cooktop Operation
Turning off the burner
Turn the knob clockwise as far as it will go to the off position.
Ensure flame extinguishes fully.
GRIDDLE BURNER KNOB
ATTENTION
The range must be level for the griddle to operate properly.
CAUTION
• Do not overheat the griddle. This can damage the
coating of the griddle.
• Do not use metal utensils that can damage the griddle
surface.
• Always turn off when not in use or lower the heat
between cooking loads.
• Do not use the griddle for other purposes, for example,
as a cutting board or a storage shelf.
• Do not cook excessively greasy foods. The grease may
spill over.
• The griddle may become very hot. Use oven gloves
when placing or removing the griddle.
• Do not remove the griddle until the cooktop grates,
surfaces, and griddle itself cool down.
• The griddle is quite heavy. Use both hands when placing
or removing the griddle.
EN
59

Publicité

Table des Matières
loading

Table des Matières