To Set The Self-Clean Mode; To Delay The Start Of Cleaning; To Change The Cleaning Time - Fulgor Milano SOFIA FSRC 4807 2P MK 2F Serie Manuel D'instructions

26 - Setting The Self Cleaning Mode
EN

To Set the Self-Clean Mode

1. Press the ON/OFF knob and select the icon
confirm with the same knob .
2. A message appears on the screen to remove all objects
or accessories from the compartment.
3. Press the [FUNCTION] knob to start door lock and
cleaning cycle.
4. The clean time is displayed automatically, its standard
value is 3 hours.
5. At the end of the programmed cleaning time, the oven
will automatically turn off.
• To stop the cleaning mode at any moment, press ON/
OFF knob.
• The Self Cleaning cycle cannot be selected if the door is
open.
• If the door is in the open position when the function
has already been selected and the [FUNCTION] knob
is pressed the latch doesn't move, the "PADLOCK" icon
will flash until the door will be closed and the lock motor
stops. When the "CLOSED PADLOCK" it is displayed, the
door cannot be opened.
• Check that the door has been locked, if door does not
lock, press ON/OFF knob and do not start self-clean;
phone for service.
• Do not attempt to open the door while the cleaning cycle
is running and the door is locked.

To Change the Cleaning Time

1. To change the setting from 3 hours, select either 2 hours
for light soil immediately after starting.
2. To change the hours, rotate the [FUNCTION] knob to the
RIGHT and select
[FUNCTION] knob to change the value, than confirm by
pressing the [FUNCTION] knob.
3. Automatically the minutes will flash, use the [FUNCTION]
knob to change the value, than confirm by pressing the
[FUNCTION] knob.
52
and then
icon, (the hours will flash), use the

To Delay the Start of Cleaning

1. Follow steps 1 through 3 above.
2. Touch the icon and verify that "STOP TIME" appears
on the display. The hours will begin flashing, use the
[FUNCTION] knob to change the value, than confirm by
pressing the [FUNCTION] knob.
3. Automatically the minutes will flash, use the [FUNCTION]
knob to change the value, than confirm by pressing the
[FUNCTION] knob.
8. When the delay time expires, self-cleaning will start.
9. At the end of the programmed cleaning time, the oven
will automatically turn off.
CAUTION
Keep in mind that the oven door will remain locked until
it is safe enough to open. The lock symbol will disappear
from the display when the door lock is released.
You will still need to exercise caution when the door lock
is released because the inside of the oven may still be hot.
After the self-clean cycle is complete the oven control
monitoring the internal temperature and the following
messages will be displayed:
• From the 460°C/860°F to 270°C/518°F= "End Self
Cleaning"
• From the 270°C/518°F to 50°C/122°F= "Waiting to
Clean"
• From the 50°C/122°F to 25°C/77°F= "Remove Residues"
(Press ON/OFF key to clear the message).
You may notice a powder ash residue in the bottom of the
oven after self-cleaning. This condition is normal. Use a
damp cloth or sponge to wipe up the residue after the oven
cools down.
Self-cleaning Tips:
If any soil remains in the oven after the self-clean cycle is
complete, you may repeat the cycle if you want.
Self-clean the oven regularly to prevent excessive soil build-
up. Doing so will make the self-clean cycle work better and
reduce smoke and odors.