Low Flame Adjustment; Adjustment For Burners With One Or Two Rings - Fulgor Milano Sofia Série Instructions D'installation

6 - Conversion for LP or NG Gas
EN

Low Flame Adjustment

DANGER
Lighting gas burners with a match is dangerous.
You should match light the burners only in an emergency.
Light a match and hold the fl ame near the burner you want
to light. Wooden matches work best.
Push in and turn the control knob slowly.
Be sure you are turning the correct knob for the burner you
are lighting.
NOTE: If the burner does not light within fi ve seconds, turn the
knob off and wait one minute before trying again.
CAUTION
If you attempt to measure the inner cone of the fl ame, please
use caution.
Burns could result.
16
This appliance is shipped from the factory with low and
medium fl ame settings adjusted.
If further adjustment is necessary, proceed as follows:
Adjustment for Burners with one or two fl ame
rings:
1. Light burner and set control knob for low fl ame.
2. Remove control knob from valve stem.
3. Remove knob seat from control panel.
4. Insert a slender, thin-blade screwdriver into the recess
behind the control knob (A or B) and engage blade with
slot in adjusting screw.
5. Turn adjusting screw to set fl ame size:
• clockwise to reduce
• counterclockwise to increase
6. Replace control knob when adjustment is completed.
LOW FLAME ADJUSTMENT
A - SIMMER
B - MAIN FLAME