Installation Information - Fulgor Milano SOFIA FSRC 4807 2P MK 2F Serie Manuel D'instructions

5 - Installation Information

EN
WARNING
• Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
• Cut Hazard
Beware of sharp edges. Use the polystyrene ends when
carrying the product. Failure to use caution could result
in minor injury or cuts.
Do not obstruct the flow of combustion air at the oven vent
nor around the base or beneath the lower front panel of
the range. Avoid touching the vent openings or nearby
surfaces as they may become hot while the oven is in
operation. This range requires fresh air for proper burner
combustion.
NEVER cover any slots, holes or passages in the oven
or cover an entire rack with aluminum foil. Doing so
blocks air flow through the oven and may cause carbon
monoxide poisoning. Aluminum foil linings may also trap
heat, causing a fire hazard.
CHOOSING RANGE LOCATION
Carefully select the location where the range will be placed.
The range should be located for convenient use in the
kitchen, but away from strong drafts.
Strong drafts may be caused by open doors or windows, or
by heating and/or air conditioning vents or fans.
IMPORTANT NOTE
When installing against a combustible surface, a
minimum riser is required for a the range, follow all
minimum clearances to combustible surfaces shown in the
illustration on Cutout Requirements page 10.
Before moving the range, protect any finished flooring and
secure oven door(s) closed to prevent damage.
Do not lift or carry the range door by the door handle.
To eliminate the risk of burns or fire by reaching over
heated surface units, cabinet storage space located above
the surface units should be avoided. If cabinet storage is to
be provided, the risk can be reduced by installing a range
hood that projects horizontally a minimum of inches beyond
the bottom of the cabinets.
All openings in the wall or floor where the range is to be
installed must be sealed.
12
TOOLS WILL YOU NEED
Remove packaging materials and literature package from
the cooktop before beginning installation.
Remove Installation Instructions from the literature pack and
read them carefully before you begin
MATERIALS PROVIDED
Gasket
Anti-tip bracket
brace abd screws
MATERIALS REQUIRED (not provided)
Joint Sealant
Pipe Fittings
NOTE: Purchase new flexible line; do not use previously used
flexible gas line.
Shut-Off Valve