Setting The Self-Clean Mode; To Set The Self-Clean Mode; To Change The Cleaning Time; To Delay The Start Of Cleaning - Fulgor Milano Sofia 30 Guide D'utilisation Et D'entretien

22 - Setting the Self-Clean Mode

EN

To Set the Self-Clean Mode

1. Rotate both knobs into the clean position.
2. CLEAN & TIME appear.
3. The clean time is displayed automatically, its standard value
is 3 hours.
4. At the end of the programmed cleaning time, the oven will
automatically turn off.
5. To stop the cleaning mode at any moment, move one of the
two knobs from the cleaning position.
Do not attempt to open the door while the door is locked. The
"AUTO LOCK" text will flash until the motor stops. When the
text is displayed, the door cannot be opened. Check that the
door has been locked and will not open before starting the
Self-Clean mode.
If door does not lock, rotate the cooking mode knob into the
OFF position and do not start self-clean; contact service.
If the door is in the open position when this mode is selected,
the "AUTO LOCK" text will flash until the door is closed. The
latch will not move until the door is closed. Do not attempt
to reopen the door while the latch is in motion as you could
damage the mechanism.

To Change the Cleaning Time

1. To change the setting from 3 hours, select either 2 hours
for light soil or 4 hours for heavy soil immediately before
starting.
2. To change the hours, touch the
3. The hours will flash.
+
4. Use or - keys to change the value.
5. To change the minutes, touch the
6. The minutes will flash.
+
7. Use or - keys to change the value Hold the key to
change by 10 minute increments.
8. Touch or wait a few seconds to confirm the new
TIME
value.
30
key.
TIME
key again.
TIME

To Delay the Start of Cleaning

1. Follow steps 1 through 7 above.
2. Touch the key and verify that "STOP TIME" appears
TIME
on the display. The hours will begin flashing.
+
3. Use or - keys to change the stop time value.
4. To change the minutes, touch the
flash.
+
5. Use or keys to change the value. Hold the key to
-
change by 10 minutes increments.
6. Touch or wait a few seconds to confirm the new
TIME
value.
7. The latch starts moving to lock the oven door, the display
shows "DELAY".
8. When the delay time expires, self-cleaning will start.
9. At the end of the programmed cleaning time, the oven will
automatically turn off.
10. "End" will appear on the temperature display, "CLEAN" on
the mode display and "TIME" on the clock display will start
flashing until the key is touched or the knob is moved
TIME
to the OFF position.
In order to check the cleaning or the stop time during a
delayed clean, simply touch the
"STOP TIME" writings are displayed.
key, the minutes will
TIME
key until "TIME" or
TIME