Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Notes
EN
•
*A zipper pull tool or equivalent is required to access the internal components of the support surface.
•
**You cannot perform these preventive maintenance checks without the InTouch footboard. See the InTouch
integrated Models 2131 and 2141, software version 4.0 or higher manual.
•
The zipper overlaps at the end and may appear to be misaligned.
Replace the following items every two years:
•
Cover assembly, top and bottom
Product serial number:
Completed by:
Date:
Cover replacement, top
Tools required:
•
Zipper pull tool or equivalent
Procedure:
1.
Apply the InTouch brakes.
2.
Unplug the support surface power cord.
3.
Remove the headboard and footboards.
4.
Lower all the siderails.
5.
Unsnap the two secure snaps (C) at the foot end corners
6.
Unsnap the four corner retainers (B)
7.
Insert a zipper pull tool or equivalent through the hole in the zipper slider to unlock.
1-20
Preventive maintenance
(Figure 1-10 on page
(Figure 1-10 on page
1-21).
2971-209-001 REV B
1-21).
www.stryker.com
Publicité
Chapitres
Table des Matières
