Steer Wheel Assembly Replacement - Stryker GoBed II MedSurg Bed Guide D'entretien

STEER WHEEL ASSEMBLY REPLACEMENT

Tools Required:
• 1/2" Combination Wrench
• Soft Hammer
Procedure:
Note
Unless otherwise indicated, refer to Figure 18,
1 . Raise the bed to the highest position .
2 . Unplug the power cord from the wall receptacle .
3 . Remove the optional steer wheel hood .
Note
When reinstalling the steer wheel hood, ensure the colored labels affixed to the hood and the brake/steer pedal match .
4 . Position the brake/steer pedal to neutral .
5 . Using a 1/2" combination wrench, remove the two nuts, two shoulder spacers, two washers, and two bolts (C1, C2,
Figure 19, page 1-66) holding the brake rods to the locking levers on both sides of the mechanism . If the optional
four-wheel brake system is present on the bed, also remove the fasteners holding the two other brake rods to the
locking levers .
6 . Using a 1/2" combination wrench, remove the two bolts (A) holding each side of the steer wheel mechanism to the
base . Keep the molded spacers (B) . Remove the assembly .
7 . Using a soft hammer, remove the two brake/steer pedals from the activation lever shafts .
8 . Keep the two locking levers (D, Figure 19,
9 . Reverse the above steps to install the new steer wheel assembly .
10 . Test the steer wheel before returning the bed to service .
Return To Table of Contents
1-64
Service Information
page 1-62, for this procedure .
page 1-66) .
280C-009-002 REV B www.stryker.com