Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEER WHEEL CASTER REPLACEMENT
Tools Required:
• (2) 1/2" Combination Wrenches
Procedure:
Note
Unless otherwise indicated, refer to Figure 18,
1 .
Raise the bed to the highest position .
2 .
Unplug the power cord from the wall receptacle .
3 .
Remove the optional steer wheel hood .
Note
When reinstalling the steer wheel hood, ensure the colored labels affixed to the hood and the brake/steer pedal match .
4 .
Position the brake/steer pedal to neutral .
5 .
Using two 1/2" combination wrenches, remove the nut/bolt (C) holding the caster to the swing arm .
6 .
Reverse the above steps to install the new caster .
www.stryker.com
Service Information
page
1-62, for this procedure .
280C-009-002 REV B
Return To Table of Contents
1-63
Publicité
Chapitres
Table des Matières
