Steer Wheel Swing Arm Assembly Replacement - Stryker GoBed II MedSurg Bed Guide D'entretien

STEER WHEEL SWING ARM ASSEMBLY REPLACEMENT

Tools Required:
• (2) 1/2" Combination Wrench
• 3/16" Allen Wrench
Procedure:
Note
Unless otherwise indicated, refer to Figure 18,
1 . Raise the bed to the highest position .
2 . Position the brake/steer pedal to neutral .
3 . Remove the optional steer wheel hood .
Note
When reinstalling the steer wheel hood, ensure the colored labels affixed to the hood and the brake/steer pedal match .
4 . Using a 1/2" combination wrench, remove the nut, shoulder spacer, washer, and bolt (C1, Figure 19,
holding the brake rod to the locking lever on the right side of the steer wheel mechanism . If the optional four-wheel
brake system is present on the bed, also remove the fasteners holding the other brake rod to the locking lever .
5 . Using a 1/2" combination wrench, remove the two bolts (A) holding the right steer wheel support to the base . Lay
the support down and keep the molded spacer (B) .
6 . Using two 1/2" combination wrenches, remove the nut, shoulder spacers and bolt (D) holding the right torsion lever
(E) to the lower part of the right counter lever .
7 . Using a 1/2" combination wrench and a 3/16" Allen wrench, remove the two nuts and two Allen screws (F) holding
the torsion levers (E) to both ends of the torque shaft (G) .
Note
When reassembling the steer wheel swing arm assembly, screw down the Allen screws before installing the nuts .
8 . Disengage the swing arm assembly from the torsion levers and remove it .
9 . Using two 1/2" combination wrenches, remove the nut/bolt (C) holding the caster to the swing arm and install the
caster on the new swing arm assembly .
10 . Reverse the above steps to install the new swing arm assembly .
11 . Test the steer wheel before returning the bed to service .
www.stryker.com
Service Information
page 1-62, for this procedure .
280C-009-002 REV B
page 1-66)
Return To Table of Contents
1-65