Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BED CASTER REPLACEMENT
Tools Required:
• #2 Phillips Screwdriver
• Jack Stand (or equivalent)
• Needle Nose Pliers
• 1/2" Combination Wrench
Procedure:
1 .
Raise the bed to the highest position .
2 .
Position the brake/steer pedal to neutral .
3 .
Place a jack stand under the frame where the defective
caster is .
4 .
Using a #2 Phillips screwdriver, remove the screw holding
the wheel cover and remove it .
5 .
Lower the bed until the caster is six inches off the ground .
6 .
Unplug the power cord from the wall receptacle .
7 .
If the caster is part of the braking mechanism, using
needle nose pliers, remove the rue ring cotter, washer, and
locking axle (A) linking the caster shaft to the locking lever .
Note
The shaft of a caster that is part of the braking mechanism must be properly oriented before mounting it to the base .
The opposite illustration shows the side of the shaft that should be facing the inside of the bed . It is the side showing the
largest hole below the cam in the neutral position .
8 .
Using a 1/2" combination wrench, remove the bolt and two washers (B) holding the caster to the base .
Note
Before tightening the bolt (B), make sure the shaft is completely inserted into the mounting socket .
9 .
Reverse the above steps to install the new caster .
Return To Table of Contents
1-66
Service Information
D
C1
Figure 19
280C-009-002 REV B
A
C2
52
B
A
www.stryker.com
Publicité
Chapitres
Table des Matières
