Brake/Steer Pedal Replacement - Stryker GoBed II MedSurg Bed Guide D'entretien

BRAKE/STEER PEDAL REPLACEMENT

Tools Required:
• 1/2" Combination Wrench
• Soft Hammer
D
F
Procedure:
1 . Raise the bed to the highest position .
2 . Unplug the power cord from the wall receptacle .
3 . Remove the optional steer wheel hood .
Note
When reinstalling the steer wheel hood, ensure the colored labels affixed to the hood match the brake/steer pedal .
4 . Position the brake/steer pedal to neutral .
5 . Using a 1/2" combination wrench, remove the two bolts (A) holding the steer wheel support on the side of the
defective pedal and lay the support down . Keep the molded spacer (B) .
6 . Using a soft hammer, remove the pedal from the activation lever shaft .
7 . Reverse the above steps to install the new pedal .
Return To Table of Contents
1-62
Service Information
D
G
F
E
Figure 18
280C-009-002 REV B
B
A
49
www.stryker.com