Repair Service; Contact Information - CareFusion Snowden-Pencer Instructions D'utilisation

Storage and Transport Conditions
After sterilization, insert assemblies should remain in
sterilization packaging and be stored in a clean, dry
environment.
Assembly
Note: Figures referenced are located on the first page of this
IFU.
1. Disable the ratchet (refer to applicable Snowden-Pencer™
Modular Handle IFU). Ensure that the handle is fully open.
(Figure 6)
2. Press and hold both assembly/release buttons on the front
of the handle. (Figure 7)
3. With both buttons engaged, slide the insert assembly into
the opening in the distal end of the handle until the flush
port is slightly seated in the handle. (Figure 7)
4. Remove fingers from assembly/release buttons and fully
insert the insert assembly until an audible click is heard.
Note: When proper assembly is achieved, the assembly/release
buttons will return to initial position and the jaws will open.
5. Verify that the jaws open and close when the handle is
actuated.
Instrument Operation
Compress and release the handle lever to close and open the
jaws.
Warranty
All Snowden-Pencer reusable insert assemblies are protected
by a full service one (1) year warranty and lifetime warranty
against manufacturer defects. Damage caused to the insert
assembly by overstress, mechanical shock, improper
processing, or repair by a party other than Snowden-Pencer is
not covered.
Repair, alteration or modification of any product by persons
other than Snowden-Pencer, or products subjected to misuse
or abuse will result in immediate loss of warranty. If Snowden-
Pencer insert assemblies are damaged by accident or when
used for a purpose other than originally intended, a repair
charge will apply.
IEC Classification for insert assemblies listed in Appendix: BF
Applied Part for non-continuous operation.

Repair Service

All insert assembly repairs must be returned to an authorized
Snowden-Pencer Representative, to the address below or to an
authorized representative for international repairs. If the repair
is covered under warranty, it will be repaired or replaced at no
charge when requested in writing. A nominal service charge will
be made for repaired insert assemblies outside the warranty.
Note: All insert assemblies being returned for maintenance,
repair, etc. must be cleaned and sterilized per these instructions
prior to shipment.

Contact Information

BD Customer Service
800-323-9088
For email inquiries:
Customer_Support@BD.com
www.bd.com
For customers outside of the USA, please contact your local
distributor.
Other Resources: To learn more about sterilization practices
and what is required of manufacturers and end users, visit
www.aami.org, www.aorn.org or www.iso.org.
9