Material Number For Valve System; Identification Key For Bus Coupler; Equipment Identification For Bus Coupler - Aventics Ethernet POWERLINK Description Du Système Et Notice D'emploi

114 AVENTICS | Bus Coupler AES/Valve Driver AV, Ethernet POWERLINK | R412018143–BAL–001–AF
Conversion of the Valve System
1
12.3.2

Material number for valve system

The material number for the complete valve system (46) is printed on the right end plate. You can
use this material number to reorder an identically configured valve system.
Note that, after a valve system conversion, the material number still refers to the original
configuration (see section 12.5.5 "Conversion documentation" on page 121).
46
12.3.3

Identification key for bus coupler

The identification key (1) on the top of the AES series bus coupler for Ethernet POWERLINK
is "AES-D-BC-PWL" and describes the unit's main characteristics:
Table 29: Meaning of the identification key
Designation
AES
D
BC
PWL
12.3.4

Equipment identification for bus coupler

The bus coupler requires a unique ID to enable the clear identification of the unit within the system.
The two equipment identification fields (4) on the top and front of the bus coupler are available
4
for this purpose.
Label the two fields as shown in your system diagram.
Meaning
Module from the AES series
D design
Bus Coupler
For Ethernet POWERLINK fieldbus protocol