Led; Address Switch; Valve Driver - Aventics Ethernet POWERLINK Description Du Système Et Notice D'emploi

AVENTICS | Bus Coupler AES/Valve Driver AV, Ethernet POWERLINK | R412018143–BAL–001–AF
4.1.2
The bus coupler has 6 LEDs.
The table below describes the functions of the LEDs. For a comprehensive description of the LEDs,
see section 11 "LED Diagnosis on the Bus Coupler" on page 106.
Table 8:
14
Designation
UL
15
UA UL (14)
16
IO/DIAG
UA (15)
S/E
17
IO/DIAG (16)
L/A 1
S/E (17)
L/A 2
18
L/A 1 (18)
19
L/A 2 (19)
4.1.3
Fig. 2:
The two rotary switches S1 and S2 for manual valve system address assignment are located
underneath the window (3).
S1
Switch S1: The higher nibble of the last block of the IP address is set at switch S1. Switch S1
is labeled using the hexadecimal system from 0 to F.
S2
Switch S2: The lower nibble of the last block of the IP is set on switch S2. Switch S2 is labeled
using the hexadecimal system from 0 to F.
A comprehensive description of addressing can be found in section 9 "Presettings on the Bus
Coupler" on page 97.
4.2
The valve drivers are described in section 12.2 "Valve zone" on page 108.

LED

Meaning of the LEDs in normal mode
Function
Monitors electronics power supply
Monitors the actuator voltage
Monitors diagnostic reporting from all modules
Monitors data exchange
Connection with Ethernet device on fieldbus connection X7E1
Connection with Ethernet device on fieldbus connection X7E2

Address switch

Location of address switches S1 and S2

Valve driver

Status in normal mode
Illuminated green
Illuminated green
Illuminated green
Illuminated green
Green, flashes quickly
Green, flashes quickly
S1
S1
S2
S2
3
79
About This Product