Device Description; Device Overview Of The Valve System And Modules - Aventics EtherNet/IP Mode D'emploi

2
1
7
Fig. 1: Bus coupler device overview with I/O modules and valve terminal (sample configuration)
1 End plate left
1)
2 Output module or input module
3 Bus coupler, type B-design
4 B-Design stand-alone module extension
1)
Up to 6 modules (input or output modules) can be connected in any combination (e.g. 3 input and 3 output modules).
2)
With separate operating instructions.
3)
Up to 3 modules (module extensions) can be integrated in any combination.
AVENTICS | EtherNet/IP™ | R412012728–BDL–001–AC
5

Device Description

The bus coupler makes it possible to control the VS via an EtherNet/IP™ field bus
system. In addition to connections for data lines and power supplies, the bus coupler
also enables you to set various bus parameters and permits diagnosis via LEDs and
the EtherNet/IP™ protocol. The following overview outlines the entire valve system
and its components. The VS itself is described in its own operating instructions.

5.1 Device overview of the valve system and modules

The valve system consists of the following parts as illustrated in fig. 1 (depending on
the order):
6
5
4
3
1)
2)3)
5 FE connection
2)
6 Valve terminal
7 Alternative FE connection using the screw from (5)
47
Device Description