Publicité
1.11 Do not put fingers or hands into the appliance.
1.12 Never put the appliance on top of the battery while using it.
1.13 Do not attempt to start a damaged battery.
1.14 Never start a frozen battery. Do not permit the internal battery of the appliance
to freeze.
1.15 Never connect the appliance to a battery or starter which is in short-circuit.
1.16 Do not use the appliance to jump start a vehicle while charging the internal battery.
1.17 Keep away from jewelry. Remove personal metal objects such as rings,
bracelets, necklaces and watches when working with a lead-acid battery. A
lead-acid battery can produce a short-circuit current high enough to weld a
ring or the like to metal, causing a severe burn.
1.18 Keep away from tools. Be extra cautious, to reduce the risk of dropping a
metal tool onto the battery. It might spark or short-circuit the battery or other
electrical part that may cause an explosion.
1.19 Never allow clamps to touch together or contact the same piece of metal.
1.20 Consider having someone close enough by to come to your aid when you
work near a lead-acid battery.
1.21 If battery acid contacts your skin or clothing, immediately flood the area with
water for at least 30 minutes. If acid enters your eyes, immediately flood the eyes
with running water for a least 10 minutes and get medical attention right away.
1.22 If battery acid is accidentally swallowed, do not induce vomiting. Seek medical
attention immediately.
1.23 Determine the voltage of the battery by referring to the vehicle owner's
manual and make sure that the output voltage of the appliance is correct.
1.24 Position the output cables to reduce any the risk of damage by the hood, door
and moving or hot engine parts. If it is necessary to close the hood during the
jumps starting process, ensure that the hood does not touch the metal part of
the battery clamps or cut the insulation of the cables.
1.25 The battery terminal not connected to the chassis has to be connected first.
The other connection is to be made to the chassis, remote from the battery
and fuel line.
1.26 Refer to the instructions for cleaning and user maintenance.
2. GENERAL INFORMATION
2.1 Description
Following the model - See page 2-3-4:
1.
Voltmeter
2.
Push button for voltmeter
3.
4-pole charging plug
4.
5-pole charging plug
5.
Buzzer - reverse polarity alarm
6.
Voltage selector
7.
Connector 12 V
8.
Connector 24 V
2.2 Voltmeter
Press the push button to show the charge level of the booster.
Half an hour after disconnecting the charger from the booster, the voltmeter must
indicate a voltage higher than or equal to 12,8 V for a full charge.
9.
Voltage detection
10.
Auxiliary connector
11.
Power fuse (300 A or 500 A)
12.
Spare power fuse
13.
Hydrogen-exhaust outlet
14.
Cigarette lighter outlet 12 V
15.
Fuse 16 A
- 7 -
Publicité
