Publicité
1.
Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope you have a lot of fun and success using your
new machine.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
We recommend:
Read through the complete text in the operating instruc-
tions before installing and commissioning the device.
The operating instructions are intended to help the user
to become familiar with the machine and take advantage
of its application possibilities in accordance with the
recommendations. The operating instructions contain
important information on how to operate the machine
safely, professionally and economically, how to avoid
danger, costly repairs, reduce downtimes and how to
increase reliability and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in your
country. Keep the operating instructions package with
the machine at all times and store it in a plastic cover
to protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information. The machine can only
be operated by persons who were instructed concern-
ing the operation of the machine and who are informed
about the associated dangers. The minimum age re-
quirement must be complied with.
In addition to the safety notices contained in this operat-
ing manual and the particular instructions for your coun-
try, the generally recognised technical regulations for the
operation of identical devices must be complied with.
2. Device description (fig. 1 + 2)
1.
Engine
2.
Fuel tank
3.
Air filter / carburettor cover
4.
Transmission
5.
Idle setting
6.
Drive shaft
7.
Drill: 7a; Ø100 / 7b; Ø150 / 7c; Ø200mm
8.
Spark plug cap
9.
Choke
10. Handle
11.
Stop switch
12. Transmission lubricating nipple
13. Gas regulating lever
14.
Locking lever
15. Tank cover
16. Fuel pump
3. Scope of delivery
• Motor casing with handle
• Drill Ø 100, 150, 200 mm
• Petrol mixing container (D)
• Locking pin 3x (A)
• Spark plug spanner (B)
• Spanner 8/10 mm
• Hexagonal spanner 4/5 mm
• Operating instructions
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, store the packaging until the warranty
period has expired.
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
www.scheppach.com
GB | 23
Publicité
