Sunrise Medical Quickie IRIS Manuel D'instructions page 23

IX. DEALER SERVICE AND ADJUSTMENT
H. ADJUSTABLE LOCKING FLIP-UP ARMRESTS
1. Height Adjustment
a.
Loosen bolt and nut (A) and remove fl ip-back tube.
b. Loosen bolts (B, C) and remove clamp (I).
c. Move the clamp (D) up or down to the desired position.
d. Tighten bolts (B, C).
e. Install the fl ip-back tube back in place and tighten bolts (C,D).
f. Repeat the process for the other armrest.
2. Angle-Adjustment
a. Loosen bolt (E).
b. Set armrest at desired angle using preset holes in armrest angle plate.
c. Tighten bolt (E).
3. Length-Adjustment (optional)
a. Remove foam grip or armpad (G) from armrest.
b. Loosen the nut and screw (F) in the adjustable fl ip-up tube.
c. Reposition the sleeve (H) at the desired length.
d. Re-tighten the screw and nut (G).
e. Put foam grip or armpad back in place.
I. CANTILEVER LOCKING FLIP-BACK ARMRESTS
1. Height Adjustment
a. Using a 5mm hex key and 13mm open end wrench loosen button head screw (A) and nut (B) on the inside
of the armrest pivot.
b. Rotate the armrest up or down to a comfortable height and tighten the hardware (A, B).
c. You should repeat the steps on the opposite armrest, and adjust both sides equally in most cases.
8
2. Level the armrest
When you adjust the armrest height, you will also need to level the armrest pad.
a. Using a 5/32-in hex key, Loosen the front pivot socket screw (F) and remove the rear socket screw (F)
from the bracket (E) so that you can level the armpad (D).
b. Once you have found the correct adjustment, re-insert the rear socket head screw (F), and tighten the
hardware.
3. Armrest Pad Adjustments
You can adjust the armrest pad forward or backwards.
a. Using a 1/8-in hex key loosen the two button head screws (C) holding the armrest pad (D) to the adjust-
ment bracket (E), and move the pad forwards or backwards.
b. When you have found the right position, re-insert the screws (C) and tighten the hardware.
You can also adjust the armrest pad laterally.
a. Using a 5/32-in hex key remove the two screws (C) holding the armrest pad (D) to the adjustment bracket
(E).
b. You can achieve an inch of adjustment laterally by fl ipping the pad 180° as shown.
c. If you still need more adjustment laterally, you can re-position the armrest pad bracket by removing the
2 socket head screws (F) that hold the bracket to the cantilever arm, and attaching the bracket on the
outside of the cantilever arm as shown.
d. When you have found the right position, re-insert the screws (F) and tighten the hardware.
9 10
6
7
23
ENGLISH
6
7
8
9
10
255050 Rev. C