Sunrise Medical Quickie IRIS Manuel D'instructions page 20

ENGLISH
X. MONO BACK STROLLER HANDLE
1. Height/Angle Adjustment
a. Press button (A) on the stroller handle so that it releases the push handle.
b. Adjust the push handles to a comfortable position.
NOTE– ALWAYS lock push handles by moving them slightly being sure to hear the mechanism click into the locked
position.
Y. FOLDING THE MONO BACK FOR TRANSPORT
CAUTION– The Z-Finity® Footrest system is rated to 165lbs (75kg)
1. Height/Angle Adjustment
a. Push down on the release lever (B) and fold the backrest forward for easier transport of the chair.
b. To return the back to the riding position just pull up on the back until it locks into place at the original
position.
NOTE– AFTER FOLDING OR UNFOLDING THE MONO BACK, ALWAYS check to make sure it is in the locked
position by moving it slightly and listening for the mechanism to click into the locked position.
Z. FOLDING/UNFOLDING FRAME (optional)
1. Unfolding
a. Attach the wheels and make sure they are locked in the axle sleeves.
b. Push down on folding struts (C) until they lock. Make sure lock handle (D) is down and double check that
the frame is locked by pushing inwards on the frames.
c. Add the seating system, and footrests.
2. Folding
a. Remove the rider, seating system, and fl ip-up the footplates. Disengage the wheel-locks.
b. Unlock the mechanism by pulling up on the lock handle (D), then using both hands, grasp the folding struts
while pushing on the locking lever release buttons (E) with your thumbs.
c. Once the chair starts to fold, push the frames together until the chair is fully folded.
d. Remove the Wheels using the quick-release buttons. The chair is ready for transport or storage.
AA. HYGIENE MEASURES WHEN BEING RE-USED
Prior to the wheelchair being re-used, it must be carefully prepared. All surfaces which come into contact with the user
must be treated with a disinfection spray.
To do this, you must use a disinfectant as authorised/recommended in your country, for rapid alcohol-based disinfection
for medical products and medical devices, which must be disinfected quickly.
Please be aware of the manufacturer's instructions for the disinfectant you are using.
In general, a complete disinfection cannot be guaranteed on seams. We therefore recommend that you dispose of seat
and back slings to avoid micro-bacterial contamination with active agents according to your local infection protection
law.
BB. CONDITIONS FOR SAFE STORAGE
• Products should be stored in a dry place: at 20 – 75% Relative Humidity.
• Protect from direct sunlight and dust for long periods.
• Away from direct heat and at a temperature between 5°C (40°F) to 40°C (104°F)
• Position and stack the packaged products according to the "this side up" arrows on the packaging.
• If a package is high and narrow and therefore potentially unstable, ensure it is well secured on the pallet or in the
racking, to prevent it from falling down.
• Do not stack anything on top of the packaged products when the "do not stack" mark on the packaging is shown.
• Product should never be stored outside and subject to the elements.
CC. INSPECT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also
perform smoothly. If you have any problems, follow these procedures:
1. Review assembly and adjustment sections to make sure the chair was properly prepared.
2. Review the troubleshooting guide.
3. If your problem persists, contact your authorized supplier. If you still have a problem after contacting your au-
thorized supplier, contact Sunrise customer service. See the introduction page located in the front of this User's
Manual for details on how to contact your authorized supplier, or Sunrise customer service.
255050 Rev. C
31
32
33 34
20
VIII. USE AND MAINTENANCE
31
32
33
34