IX. DEALER SERVICE AND ADJUSTMENT
W. VENTILATOR HANGER BRACKET
1.
Attach the ventilator to the ventilator bracket.
a.
Position the ventilator above the hanger bracket (D) and slide it into the bracket.
b.
Using the 2 nylon straps (E) (F) secure the Ventilator to the hanger bracket and make sure any
cords and tubes are secured and not in danger of pinching in any of the components of the
chair.
X. FIXED STROLLER HANDLE
1.
Angle Adjustment of the Stroller Handle
Depress both black push buttons (H) at the same time. This disengages the stroller handle and allows
it to rotate freely. Releasing the push buttons positively locks the adjustable stroller handle in the
desired position.
2.
Height Adjustment
a.
Remove both bolts (G) from the backrest tube (one on each side).
b.
Reposition backrest height.
c.
Re-tighten both bolts (I) in the desired location.
Y. ADJUSTABLE STROLLER HANDLE (MONO BACK)
39
1.
Height Adjustment
a.
Using a 5/32-in hex key loosen both screws ( I ) from the Stroller tube attachment clamp (H)
(one on each side).
b.
Reposition stroller handle height by sliding the assembly up or down in the channel.
c.
Re-tighten both screws ( I ) in the desired location.
2.
Stroller handle to Push handle conversion
a.
Loosen both screws (Do not Remove) ( I ) from the Stroller tube attachment clamp (H).
b.
Remove the screws that hold the cap ( J ) to the Mono Back, remove the endcap, and slide the
brackets up and off of the Mono back rail.
c.
Reposition the stroller handles in the push handle confi guration (K) or (L).
d.
Re-tighten screws in both clamps once you have them in the desired location.
37
38
40
41
29
ENGLISH
37
38
39
40
41
255050 Rev. C