Télécharger Imprimer la page

Sunrise Medical Quickie IRIS Manuel D'instructions page 22

Masquer les pouces Voir aussi pour Quickie IRIS:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

ENGLISH
3.
Axle Position Adjustment
a.
Remove both wheels from the chair.
b.
Remove the bolts (A) from the axle plate (B) on both sides of the chair.
c.
Reposition the axle plate in desired position.
d.
Insert and tighten bolts (A).
4.
Axle Height Adjustment
a.
Loosen and remove bolts (A).
b.
Set axle at desired height using pre-set holes in the axle plate (B) on both sides.
c.
Replace and tighten bolts.
E. HUB LOCK ADJUSTMENT
1.
To adjust the cables
a.
Loosen jam nut (C) using a 10mm wrench.
b.
Turn adjustment screw (D) in our out as necessary. Turning screw upward will loosen cable, turning
downward will tighten cable.
c.
Re-tighten jam nut (C) against lever mount.
d.
Repeat steps for opposite side of chair as necessary.
2.
To adjust lever position
a.
Remove socket screw (E) and washer (F) from lever and backrest.
b.
Choose desired hole in backrest to mount lever and re-install screw and washer.
c.
Repeat steps for opposite side of chair.
F. WHEEL LOCKS
4
1.
Adjustment
a.
Evenly loosen both screws (G). Do not attempt to remove one screw at a time.
b.
Slide assembly toward rear wheel until clamp embeds into tire to prevent wheel movement, when in
locked position.
c.
Tighten screws (G).
G. SINGLE-POST ARMREST RECEIVER
1.
Adjusting Armrest Receiver Fit
To tighten or loosen the fi t of the armpost in the receiver:
a.
Loosen the 4 set screws (J) by using a 5/64-in Hex Key.
b.
With the armrest assembly in the receiver (K) press fi rmly on the outside of the receiver.
c.
Maintain pressure on the receiver and re-tighten two of the set screws (J).
d.
Remove the armrest assembly and re-tighten the remaining two set screws.
e.
The armrest will fi t fi rmly in the receiver and lessen any noise that may result from vibration.
2.
Moving the Receiver location
a.
Loosen the 3 bolts (I) holding the clamp halves (H) together (do not remove them).
b.
Slide the clamp so that armrest is at the correct position.
c.
Tighten the 3 bolts (I).
255050 Rev. C
2
2
3
5
IX. DEALER SERVICE AND ADJUSTMENT
22
2
3
4
5

Publicité

loading

Ce manuel est également adapté pour:

Zippie iris