Fifth Wheel Assembly Replacement - Stryker 1089 Manuel D'entretien

FIFTH WHEEL ASSEMBLY REPLACEMENT

Tools Required:
• 1/2" Socket
• 3/8" Drive Ratchet
• Needle Nose Pliers
• Bungee Cords
• 3/8" Drive Torque Wrench (ft-lb)
Procedure:
1 . Pump the stretcher all the way up .
2 . Raise both siderails to the up and latched position .
3 . Using bungee cords, support the raised base hood .
4 . Using a 1/2" socket, remove the bolt that holds the fifth wheel cam drive link to the cam .
5 . Using a 1/2" socket, remove the two bolts that secure the fifth wheel assembly to the base frame .
6 . Using needle nose pliers, remove the pump pedal return spring from the fifth wheel bracket .
7 . Using needle nose pliers, remove the foot end jack release rod from the release pedal .
8 . Remove the release rod .
9 . Working from the patients left side, rotate the fifth wheel assembly counter clockwise while lifting the fifth wheel
assembly up and out .
10 . Reverse steps to reinstall . Torque all bolts to 13 ± 2 ft-lb .
11 . Verify proper operation of the unit before returning it to service .
www.stryker.com
Service Information
1089-009-006 REV G
Return To Table of Contents
1-21
English