Cell Assembly Replacement Kit - Stryker XPRT 2950 Manuel D'utilisation

CELL ASSEMBLY REPLACEMENT KIT

Required Tools:
• Tubing Cutter
• Rubbing (Isopropyl) Alcohol
1 . Unplug the support surface power cord from the power source .
2 . Unzip top cover (counter-clockwise) and remove .
3 . Cut spiral tubing just above 90 degree fitting from head box, four places . Refer to Figure 1 .
4 . Remove existing 90 degree fittings from head box and replace with new 90 degree fittings, four places . Refer to
Figure 2 for orientation .
www.stryker.com
Service Information
Figure 1
Figure 2
2950-109-005 REV B
Return To Table of Contents
1-49
English