Torque Specification - Prophete TREKKING Notice D'utilisation

TORQUE SPECIFICATIONS
DANGER OF DAMAGE AND ACCIDENTS!
• The screws and nuts installed on the bicycle must be checked for tight fit at re­
gular intervals (see maintenance plan) and may need to be tightened or re­tigh­
DANGER
tened to the proper strength. Only this can ensure that the bicycle permanently
complies with the safety­technical requirements and works properly.
• If screw and nuts are tightened too far, they may break.
• If parts are marked with torque specifications, these must be complied with.
• The torque specifications for other screw connections do not apply to the ad­
justment screws at the gearshift and brake components.
The torque wrench permits precise compliance with the tightening torques.
Wheel nuts, front (motor front)
Wheel nuts, rear (motor front + middle)
Wheel nuts, front (motor rear + middle)
Wheel nuts, rear (motor rear)
Foot pedal arm, steel
Foot pedal arm, aluminium
Pedals
Handlebar clamp block screw (M6)
Handlebar clamp block screw (4xM5)
Lateral clamping screws (A­head stem)
Angle adjusting screw (stem)
Stem Steerer Clamp (M8)
Brake shoe fixing
Brake disc fixing
Seatpost clamp ring
Saddle clamp
Damper / Shock
Other steel screws
Size / strength class
M3
M4
M5
M6
M8
50 Nm
25–30 Nm
25­30 Nm
50 Nm
30 Nm
30–35 Nm
30–35 Nm
10–14 Nm
6 Nm
9–11 Nm
18­30 Nm
20­30 Nm
5–7 Nm
5–7 Nm
8–12 Nm
18–22 Nm
10 Nm
5.6 6.8 8.8
0.7 Nm 0.9 Nm 1.2 Nm
1.7 Nm 2. 1 Nm 2.8 Nm 4. 1 Nm
3.4 Nm 4.3 Nm 5.5 Nm 8. 1 Nm
5.9 Nm 7.3 Nm 9.6 Nm 14 Nm
14.3 Nm 17.8 Nm 23 Nm
TORQUE SPECIFICATIONS
Other
VA screws A2/A4
10.9 50 70
1.7 Nm ­ ­
­ ­
1.7 Nm 3.5 Nm
3 Nm 6 Nm
34 Nm 7. 1 Nm 16 Nm
80
­
­
4.7 Nm
8 Nm
22 Nm
EN 75