Prophete TREKKING Notice D'utilisation page 141

SWITCH THE DRIVE SYSTEM ON/OFF
1. Insert the battery into the e-bike (see Battery chapter).
2. To wake the battery from sleep mode, press the button on the battery as needed.
3. Hold down the
144
4. With the KeyCard function activated, hold the e-bike key (not the master key card!) against the sen-
sor field of the operating unit.
145
The drive system is switched off by holding down the button
onds. This effectively locks it against unauthorised access.
• If you mistakenly use the master key card instead of the e­bike key when switch­
ing on you will not be able to use the key to switch on the drive system after­
wards. You must first " teach" the key again.
TEACH SPARE KEY
With the Key Card you can teach a new spare key. Proceed as
157
follows:
1. Press the button
144
2. Hold the master key card
the control unit
145
3. Hold the first key against the transponder field
coded and "Key2" then appears on the display.
4. Now take the second key and also hold it against the tran-
sponder field.
Both keys are now coded and can be used immediately.
• Note that at least one of the keys will no longer work if you teach the key card in­
stead of a key. However, you can repeat the teaching procedure at any time and
teach the second key properly.
PROLOCK
For systems with the proLock function, the frame ring lock unlocks automatically when the drive system
is switched on. To secure it, press the lever down as you would with a conventional ring lock.
OPERATE THE DRIVE SYSTEM
The drive system assists you whilst pedalling with additional motor power up to a speed of 25 km/h. You
can freely choose between the assistance levels
button of the control unit for a duration of approx. 2 seconds.
for 2 seconds.
against the transponder field of
157
. "Key1" appears on the display.
of the control unit for approx. 2 sec-
144
. The key is
145
at any time:
155
DRIVE SYSTEM
157
EN 49