Prophete TREKKING Notice D'utilisation page 111

STEM WITH ANGLE ADJUSTMENT
DANGER OF DAMAGE AND ACCIDENTS!
• The stem must not be pulled out beyond the mark! The mark of the minimum in­
sertion depth must not be visible.
DANGER
SETTING THE POSITION AND HEIGHT
1. Loosen the clamp screw
2. 2. Adjust the handlebar position or stem height to suit you. Al-
ways observe the mark of the minimum insertion depth
warranty if this is not observed!)
3. Tighten the clamp screw
fication (s. chapter Torque specifications).
SET STEM ANGLE
1. Loosen the lateral clamp screw
socket wrench.
2. Now adjust the desired angle at the stem.
3. Then tighten the clamp screw
specification (s. chapter Torque specifications).
SETTING THE HANDLEBAR INCLINATION
1. First loosen the clamp block screw of the handlebar
ment with a 4 or 5 mm hexagonal socket wrench.
2. Adjust the inclination angle of the handlebar.
3. Tighten the clamp block screw again well (s. chapter Torque spec-
ifications).
4. Turn the handlebar attachments (e.g. brake lever) back to the
starting position if necessary.
with a 6 mm hexagon socket wrench.
44
again according to the torque speci-
44
with a 6 mm hexagonal
43
again according to the torque
43
. (No
45
43
attach-
46
HANDLEBAR
44
45
46
EN 19