Removing The Rear Wheel - Prophete TREKKING Notice D'utilisation

REMOVING THE REAR WHEEL

1. Use the turning rotary handle to shift to the 1st gear.
2. V-brake rim brake: Disconnect the brake cable
out the wheel more easily later.
Hydraulic rim brake: Open the quick-clamping lever
brake [OPEN].
3. Hydraulic rim brake: Take the brake cylinder
socket in order to take out the wheel more easily later.
193
4. Release the brake counter-holder on the left side of the E-bike
.
194
5. Release the axle nuts on both sides of the rear wheel with a 15
mm wrench.
6. Take the two axle nuts including the safety washers
axle.
7. Pull out the rear wheel from the drop-out.
8. In order to release the rear wheel from the shift cable, turn the
circlip by approx. 45° counter-clockwise. Now you can dis-
196
connect the circlip and the actuating lever from the rear wheel.
INSTALLING THE REAR WHEEL
1. Place the actuating lever on the hub of the rear wheel. Observe
that the yellow marks of the actuating lever cover the yellow
marks of the hub
197
2. Place the circlip on the actuating lever and turn it by approx.
45° clockwise. ( +
196
3. Place the rear wheel into the drop-out.
4. Apply the safety washers on the axle so that the interlock is in
the drop-out ( ).
198
5. Fasten the rear wheel with the axle nuts. Ensure that the wheel
is placed straight in the holder and that the chain is appropri-
ately tensioned (see chapter Chain tension).
6. Attach the counter-holder bracket on the left side with the pipe
clamp screw connection at the frame (
7. V-brake rim brake: Connect the brake cable
Hydraulic rim brake: Push the brake cylinder
cantilever socket
193
8. Hydraulic rim brake: Close the quick-clamping lever
[CLOSE]. If the lever closes too easily, the quick-clamping screw
must be adjusted (see chapter Brakes).
9. Check that the rim brake works properly. Adjust it if necessary
(s. chapter Brake).
10. Set the gearshift (s. chapter Setting the gearshift).
192
.
)
197
).
194
189
.
in order to take
189
of the rim
181
off the cantilever
off the
195
again.
back onto the
192
191
GEARSHIFT
192
191
194 195
196
for mounting align the
yellow markings on each
other
ratched
rotate by 45°
monting ring
fix the bracket to the switch arm
properly
197
ratched
yellow marker
align
switching arm
cover
drive unit
note
direction
yellow marker
198
backup disk
chapping nut
EN 61
193