Prophete TREKKING Notice D'utilisation page 112

HANDLEBAR
A-HEAD STEM
For the A-Head stem, the handlebar position, the handlebar inclina-
tion and, depending on the model, the angle setting may be adjusted.
The handlebar height, however, cannot be set.
SETTING THE POSITION
1. Loosen the lateral clamp screws
mm hexagonal socket wrench.
2. Align the handlebar.
3. Tighten the clamp screws again well (s. chapter Torque specifi-
cations).
SETTING THE INCLINATION
1. First loosen the clamp spindle screw of the handlebar sleeve
with a 5 mm hexagonal socket wrench.
2. Adjust the inclination angle of the handlebar.
3. Turn the handlebar attachments (e.g. brake lever) back to the
starting position.
4. Tighten the clamp spindle screw
specifications).
SET STEM ANGLE
1. Loosen the lateral clamp screw
agonal socket wrench respectively.
2. Now adjust the desired angle at the stem.
3. Then tighten the clamp screw
torque specification (s. chapter Torque specifications
4. Tighten the screw
51
SETTING THE STEERING PLAY
In order to set the play in the steering, tighten the upper setting
screw with a 5 mm hexagonal socket wrench. The setting screw
48
should be tightened until the bearing is play-free. It does not need to
be tightened firmly necessarily.
EN 20
of the stem with a 4 or 5
47
again well (s. chapter Torque
49
/ / with a 5 or 6 mm hex-
50 52 53
/ / again according to the
50 52 53
according to the torque specification.
47
49
49
50
53
48
51
52