Prophete TREKKING Notice D'utilisation page 120

DAMPER (SHOCK)
tion (38 mm). This corresponds to approx. 6 to 8 mm in the installed damper. If the SAG value is excee-
ded or not reached, the air pressure of the damper must be adjusted.
MEASURING THE SAG VALUE
1. Attach a cable tie to the piston
2. Sit on the bike in the riding position. Do not rock to avoid falsifying the SAG value.
3. Carefully get off of the bicycle.
4. Measure the negative deflection (SAG value) between the dust seal
tie.
SETTING THE DAMPER
DANGER OF DAMAGE AND ACCIDENTS!
• Do not exceed the maximum air pressure released for the damper (20.7
bar/300psi). Damage to the damper and frame may occur.
DANGER
Use an air pump with pressure gauge to set or check the air pressure.
1. Take off the valve cap
2. Apply the air pump to the valve of the damper and check the air pressure at the pressure gauge.
3. Check the air pressure if necessary.
LOCKOUT
The lockout function completely blocks the deflection of the dam-
per.
SWITCHING THE SUSPENSION ON/OFF
Turn the lever towards LOCK blocks the spring travel. Reactivate
83
the spring function by turning the lever towards OPEN.
EN 28
and push it to the dust seal
82
.
84
.
81
of the damper and the cable
81
83
84