First Commissioning | Inspections Before Starting A Ride; Initial Operation - Prophete TREKKING Notice D'utilisation

INTENDED USE • FIRST COMMISSIONING | INSPECTIONS BEFORE STARTING A RIDE
FIRST COMMISSIONING &
INSPECTIONS BEFORE STARTING A RIDE
DANGER OF DAMAGE AND ACCIDENTS!
• Check whether your E­bike is safe for operation before every ride. Remember
that your E­bike may have fallen over when you did not see it or that third parties
WARNING!
may have manipulated it.
• Perform the following inspections before every ride and make any settings that
are necessary. Non­observance may lead to damage to the E­bike or failure of
important parts!

INITIAL OPERATION

The E-bike was delivered in the pre-installed condition for shipping-technical reasons. This means that
not all parts and screws will be tightened ex works. Before initial commissioning, you must tighten and
may have to set the following components:
• Saddle clamp
• Headlights
• Handlebar, stem and any
handlebar attachments (such as brake grips,
bell, gearshift lever, rotary handle switch, display/operating unit)
For more detailed information about setting and installation, see the following chapters of the E-Bike
components.
BEFORE STARTING THE RIDE
Before every ride, you must check the following parts for function or tight fit:
• Charge the rechargeable battery with the enclosed charger
• brakes (incl. tightness at hydr. brake system)
• quick-clamp
• deflection/damper/shock
• handlebar
• pedals
• rims (check for wear and concentricity)
• tyres (check for damage and barometric pressure)
Additionally, you must comply with the intervals indicated in the maintenance plan for regular inspec-
tion and repair and observe the care and maintenance instructions (see chapter Maintenance | Care).
EN 16
• Pedals
• Basket
• Lighting
• spokes
• bicycle bell
• saddle
• gearshift