Quick Clamp - Prophete TREKKING Notice D'utilisation

QUICK-CLAMP
DANGER OF ACCIDENT!
• Ensure before starting your ride that all quick­clamps are closed with sufficient
tensing force. If the quick­clamps are not closed sufficiently, parts may come
WARNING!
loose.
• The lever of the quick­clamp must be completely flush and must not stand off!
Wheel quick­clamps and frame quick­clamps always must point backwards for
reasons of safety (when viewed in the cycling direction).
• If the quick­clamp lever generally can be closed very easily or trusted when clo­
sed, the pre­tension will not be sufficient. Adjust the quick­clamp then.
A quick-clamp comprises a lever
and a counter-screw
68
Release the quick-clamp by flipping over the lever. To close, push the lever
back again until it is completely flush. On the first half of the closing
movement, the lever must move relatively easily; on the second half, it
must move much stiffer. If this is not the case, the quick-clamp must be
adjusted, since it does not have enough tension.
SETTING THE QUICK-CLAMP
1. Release the lever
69
2. Adjust the pre-tension with the hexagonal screw
hexagonal socket wrench. For quick-clamps with knurled screw
you can adjust the settings manually.
3. Push the quick-clamp lever
lever must be flush entirely.
SET THE AXLE QUICK-CLAMP
1. Release the lever
72
2. Set the pre-tension with the clamping nut
3. Push the quick-clamp lever
must be flush entirely.
/ that produces the clamping force
69 71
or knurled nut that sets the pre-tension.
70
/ of the quick-clamp.
71
/ back again with enough force. The
69 71
of the axle quick-clamp.
73
back again. The lever
72
with a 5 or 6 mm
68
,
70
OPEN
CLOSE
72
QUICK-CLAMP
68
69
70
71
73
CLOSE
EN 25