Mounting Input/Output Module(S) - Aventics CANopen Mode D'emploi

132 AVENTICS | CANopen | R412005742–BDL–001–AD
Disassembly/Exchange
7. Make all the presettings on the new bus coupler (4) (see
"Making presettings" on page 113).
8. Re-establish the electric connections.
9. Check the configuration and adjust it if necessary (see
"Configuring the bus system" on page 122).
8.2

Mounting input/output module(s)

Observe the following when adding an input/output module to
the valve system:
Applied electric voltage and high pressure
Danger of injury from electric shock and sudden pressure
drops.
Make sure that the system is not under voltage or
O
pressure!
Open inputs/outputs
Danger of electric shocks caused by contact, short circuits, or
damage to the system.
Always close unused inputs or outputs with M12 and M8
O
protective caps (see accessories) to comply with the
IP 65 protection class.
CAUTION
CAUTION