Mounting The Accessories - Aventics RTC-BV Notice D'instruction

AVENTICS | RTC/CKP | R402003540–BAL–001–AG | English
6

Mounting the accessories

All accessories can either be ordered when the cylinder is
being configured, or separately. They are always supplied
unfitted.
Mount the compensating coupling S44 16...80 mm
for RTC-BV
The compensating couplings for RTC-BV can be used to
compensate all types of offset if an external guide of the
load is available. When using the compensating coupling
an external guide of the load is mandatory.
Mounting the compensating coupling S44 16...80 mm for RTC-BV
O Mount the lower part of the compensating coupling to
the slide with the screws supplied. Attach the load to
the upper part of the compensating coupling, either
from below or from above with suitable screws.
Tightening torque according to table 3.
Tab. 3: Tightening torque, compensating coupling S44
Piston size (mm)
Screw Ø
Number
Tightening torque
(grade 8.8)
Connection kit
Used on cylinder versions CKP and CKP-CL to connect with
other cylinders of the same version for multi-axis
systems.
16...25 32...50 63...80
M4 M6 M8
8 8 8
3 Nm 10 Nm 24 Nm
CKP – Mounting the connection kit
A
4x
4x
Mounting the connection kit, CKP series (variant A)
4x
4x
Mounting the connection kit, CKP series (variant A)
O Mount the angle bracket to the slide using the included
screws according to one of the illustrated alternatives
A or B. Tightening torque according to table 3.
The opposite side of the angle bracket is used to attach a
cylinder of the same type, either in a horizontal or vertical
position.
21
B