During commissioning
During operation
During cleaning
AVENTICS | CANopen | R412005742–BDL–001–AD
Ground the modules and the valve system. Observe the
W
following standards when installing the system:
– DIN EN 50178, classification VDE 0160
– VDE 0100.
Installation may only be performed in a voltage-free and
W
pressure-free state and only by a qualified technician. In
order to avoid accidents caused by dangerous movements
of the actuators, electrical commissioning is to be carried
out only in a pressure-free state.
Do not put the system into operation before it is completely
W
assembled as well as correctly wired and configured, and
after it has been tested.
The device is subject to the restrictions of the IP65
W
protection class. Before commissioning, make sure that all
the connection seals and plugs are leaktight to prevent
fluids or foreign bodies from penetrating the device..
Make sure that there is a sufficient exchange of air or
W
enough cooling if your valve system has any of the following:
– Complete equipment
– Continuously loaded solenoid valves
Never use solvents or aggressive detergents. Only clean the
W
device using a slightly damp cloth. Only use water to do this
and, if necessary, a mild detergent.
3
Applications
The bus coupler is used to control valves via the CANopen field
bus system. Input/output modules allow electrical input and
output signals to be output via the valve system's bus
connection.
The bus coupler is designed for use as a slave only on a
W
CANopen bus system in accordance with EN 50170 Part 2.
95
Applications