Storz Techno Port 80407 Manuel D'utilisation page 68

3 Inbetriebnahme des
TECHNO PORT Monitors
3.13 Betriebsmodi und Menüführung
Level 2A
Level 3 functions
Level 3
Level 4 functions
Level 4
66
3
3.13 Operating modes and menu navigation
Level 1:
Back to Level 1.
Menu wheel:
Activates the control keys for the next level. You can move through several levels by
repeatedly pressing the menu wheel.
Level 1:
Back to Level 1.
White balance:
Enables the user to carry out a manual white balance. Point the tip of the videoscope at
a white surface and press the softkey.
1 NOTE: The performance of a white balance is visualized via a progress bar in the
menu bar.
Data transfer:
Enables the user to carry out a manual data transfer from the SD memory card to the
USB stick. Data transfer may take several minutes.
The button is deactivated during this time.
1 NOTE: The 'Data transfer' button is deactivated if no USB stick is connected or
if the USB stick is too small.
Menu wheel:
Activates the control keys for the next level. You can move through several levels by
repeatedly pressing the menu wheel.
Level 1:
Back to Level 1.
Reset:
Allows all settings to be reset to the factory settings.
1 NOTE: The camera settings for brightness, contrast, saturation and hue are
reset to the recommended values.
1 NOTE: The settings for image rotation, key lock and the Freeze function are
reset to the default settings.
Delete content of the SD memory card:
All the contents of the SD memory card are deleted by pressing the softkey for an
extended period (approx. 2 seconds). Deletion may take a few seconds and is indicated
by the non-active symbols.
1 NOTE: The deletion process is visualized via a progress bar in the menu bar.
Keep the key held down until the progress bar in the menu bar is complete.
Menu wheel:
Activates the control keys for the next level. You can move through several levels by
repeatedly pressing the menu wheel.
Level 1:
Back to Level 1.
Installing the
TECHNO PORT monitor