Publicité
Les langues disponibles
Les langues disponibles
3 Using the Source/Load Functions
To program a low-voltage limit (under-voltage inhibit) of 2 V, and enable the inhibit mode:
VOLT:INH:VON 2,(@1)
VOLT:INH:VON:MODE LIVE,(@1)
Advanced Source Settings
Advanced properties are configured in the Advanced Source Settings window. Press the Settings key
to access the Source Settings window. Navigate to and select the Advanced button. The following
dialog illustrates the advanced settings for Current Priority mode.
+Max and -Max - specifies the maximum or fastest allowable slew rate when checked. Unchecking
these boxes lets you enter a slower slew rate in the appropriate fields. Separate slew settings can be
programmed for Current Priority, Voltage Priority, Resistance Priority, and Power Priority modes
Track - lets the negative slew rate track the positive slew rate when checked. Un-check this box if you
want to program asymmetrical positive and negative slew rates. If asymmetrical rates are
programmed and tracking is turned on, the negative value is changed to track the positive value.
Sense - The default sense setting is Local, where the sense terminals are connected directly to the
input terminals. If you are using remote voltage sensing as explained under
4-Wire
Sense, you must
disconnect the sense terminals from the input terminals. Selecting the 4-Wire item from the dropdown
disconnects the sense terminals from the output terminals. This lets you use remote voltage sensing.
From the remote interface:
To set the current slew rate to 2 Amps/second:
CURR:SLEW 5,(@1)
To set the negative current slew, turn coupling (tracking) off. Then set the negative current slew:
CURR:SLEW:COUP OFF,(@1)
CURR:SLEW:NEG 3,(@1)
To set the front panel sense terminals to remote sensing:
VOLT:SENS:SOUR EXT,(@1)
To query the setting of the front panel sense terminals:
VOLT:SENS:SOUR? (@1)
Keysight N6705C User's Guide
97
Publicité
