Publicité
Les langues disponibles
Les langues disponibles
3 Using the Source/Load Functions
Configuring Parameters Common to all Arbs
From the front panel: The following properties are common to most Arb functions:
Parameter
Description
Return to DC Value
The parameter setting returns to the DC value that was in effect prior to the Arb.
Last Arb Value
The parameter setting remains at the last Arb value after the Arb completes.
Edit Points
Create a user-defined Arb from the present Arb property values. This lets you edit specific points in the standard arbit-
rary waveform. This function (button) is not available on User_Defined, Constant-Dwell or Sequence Arbs.
Continuous
Check to repeat the Arb continuously.
Repeat Count
The number of times the Arb repeats. Except for CD Arbs, the maximum repeat count is about 16 million. The maximum
repeat count for voltage and current CD Arbs is 256.
Close
Saves and closes the Properties window.
From the remote interface:
The parameter setting returns to the DC value that was in effect prior to the Arb.
ARB:TERM:LAST OFF,(@1)
The parameter setting remains at the last Arb value after the Arb completes.
ARB:TERM:LAST ON,(@1)
Create a user-defined Arb from the present Arb property values (same as Edit Points button):
ARB:CURR:CONV (@1)
ARB:VOLT:CONV (@1)
Specify the repeat count of the Arb, or specify continuous repetition (INF):
ARB:COUN 10,(@1)
ARB:COUN INF,(@1)
120
Keysight N6705C User's Guide
Publicité
