Publicité
Les langues disponibles
Les langues disponibles
4 Using the Measurement Functions
Symbol/Field
1 Vertical Volts/Div.
2 Vertical Offset
3 Trigger Level
4 Horizontal Time/Div
5 Horizontal Offset
6 Marker 1/Marker 2
Data Logger Properties
From the front panel:
With the Data Logger View displayed, press the Properties key to access the Scope Properties
window.
158
Description
Makes the waveform bigger or smaller vertically in relation to its ground reference. Specified in
volts/division or amps/division on the y axis. On outputs with multiple ranges, when Knob Con-
trol is selected in the Scope Range Property window, adjusting the vertical gain will automatically
select lower measurement ranges for better resolution. If the vertical gain causes the trace to be
out of view, arrow symbols will indicate the direction of the trace .
Moves the ground reference of the trace up or down in relation to the horizontal center line of the
grid. The offset popup that appears in the upper right corner of the display shows how far the
ground reference of the selected trace is above or below the horizontal center line of the grid.
Positive values indicate that the center line is above the ground reference. Negative values
indicate that the center line is below the ground reference.
Moves the trigger level up and down when a voltage or current level is the trigger source. The
trigger level is identified by the
indicates the direction of the trigger level.
Push the Trigger Level knob to auto-scale the traces on the display.
Zooms in or out of the data so that you can view waveform details. The numbers on the bottom
of the display indicate the location of the data that is being viewed relative to the entire data log.
Moves the grid area to the right or left along the logged data.
Moves the measurement markers right or left. Press Data Logger to display the markers.
Markers are displayed on the selected trace. Values at the bottom of the display are referenced to
the intersection of the markers. If a marker is out of view, an arrow indicates the direction of the
marker
.
Push the Marker 1 or Marker 2 knobs to reset the markers. When pushed, the following menu
appears.
Push the Enter key to Reset the marker. Push Enter again to undo the reset action. Scroll down
and select Marker options to access the Datalogger Marker Properties window. Scroll down and
select Jump to peak to move the marker to the peak measurement point of the trace.
symbol. If the trigger level is out of view, an arrow
Keysight N6705C User's Guide
Publicité
