Publicité
Les langues disponibles
Les langues disponibles
3 Using the Source/Load Functions
Step 3. Configure the final steps common to all Arbs.
Refer to
Configuring Parameters Common to all Arbs
at the end of this section.
From the remote interface:
Select the Arb Type and Shape:
ARB:FUNC:TYPE VOLT,(@1)
ARB:FUNC:SHAP RAMP,(@1)
Enter the values for the level before and after a voltage ramp:
ARB:VOLT:RAMP:STAR 0,(@1)
ARB:VOLT:RAMP:END 5,(@1)
Enter the time before the pulse, the time of the pulse, and the time after the pulse:
ARB:VOLT:RAMP:STAR:TIM 0.25,(@1)
ARB:VOLT:RAMP:RTIM 0.5,(@1)
ARB:VOLT:RAMP:END:TIM 0.01,(@1)
Configuring Staircase Arbs
Step 1. Select the Arb Type and Shape. Power and resistance types apply to
:
Press the Arb key twice or press the Arb key and then Properties to access the Arb Selection window.
In the Arb Type dropdown, select the Arb type. Then select Staircase.
Step 2. Configure the Staircase Properties:
Press the Properties key or select the Arb Properties button. Then program the following parameters:
104
Keysight N6705C User's Guide
Publicité
