Publicité
Les langues disponibles
Les langues disponibles
3 Using the Source/Load Functions
Refer to under
Importing and Exporting Arb Data
later in this section for information on how to create
.csv current or voltage data files.
Step 3. Configure the final steps common to all Arbs.
Refer to
Configuring Parameters Common to all Arbs
at the end of this section.
From the remote interface:
Select the Arb Type and Shape:
ARB:FUNC:TYPE VOLT,(@1)
ARB:FUNC:SHAP UDEF,(@1)
Enter the voltage values and dwell-times for five voltage steps:
ARB:VOLT:UDEF:LEV 1,2,3,4,5,(@1)
ARB:VOLT:UDEF:DWEL 1,2,3,2,1,(@1)
Generate an external trigger signal at the start of a voltage step (the trigger is generated at the start
of step #3):
ARB:VOLT:UDEF:BOST 0,0,1,0,0,(@1)
Configuring Sine Arbs
Step 1. Select the Arb Type and Shape. Power and resistance types apply to
:
Press the Arb key twice or press the Arb key and then Properties to access the Arb Selection window.
In the Arb Type dropdown, select the Arb type. Then select Sine.
Step 2. Configure the Sine Properties:
Press the Properties key or select the Arb Properties button. Then program the following parameters:
108
Keysight N6705C User's Guide
Publicité
