Publicité
Les langues disponibles
Les langues disponibles
Standard View
Symbol/Field
1 Trace Controls
2 Data Bar
3 Scope Traces
4 Output Pop-ups
5 Out of View Arrows
6 Ground Reference
Keysight N6705C User's Guide
Description
Identifies the volt/div. or curr/div. setting. √ indicates the trace is on.
Dashes (----) indicate the trace is off.
Select the trace and press Enter to turn it on or off.
The data bar represents all of the waveform data that has been collected.
The yellow part indicates the portion of the data that is visible on the display.
The black part represents the data that is not visible.
Voltage trace labels appear on the left side of the grid (V1 V2, V3, V4).
Current trace labels appear on the right side of the grid (I1, I2, I3, I4).
Power trace labels appear on the center of the grid (P1, P2, P3, P4).
If a portion of a trace is red, it means that portion of the trace is out of range. Push the Trigger Level
knob to autoscale the traces. This will trigger a new measurement.
Only Models N676xA and N678xA SMU can display power traces.
Turning the voltage and current knobs displays a pop-up dialog showing the present output
settings.
Pushing the voltage and current knobs displays a pop-up dialog allowing the following actions:
• Lock/Unlock the voltage or current knobs.
• On Models N678xA, select a limit parameter to control or select limit tracking.
Indicate that the trace, V1 in the figure, is out of view.
Use the Vertical Volt/Div knob or the Vertical Offset knob to bring the trace into view.
Push the Trigger Level knob to autoscale the traces. This will trigger a new measurement.
The ground reference of the trace. Ground references are offset so that they do not overlap. The
ground reference offset value is referenced to the horizontal center line of the grid.
4 Using the Measurement Functions
143
Publicité
