Télécharger Imprimer la page

Keysight N6705C Mode D'emploi page 163

Masquer les pouces Voir aussi pour N6705C:

Publicité

Les langues disponibles

Les langues disponibles

4 Using the Measurement Functions
To select a voltage trigger level and slope on output 3 for the datalog:
TRIG:DLOG:VOLT 10,(@3)
TRIG:DLOG:VOLT:SLOP POS,(@3)
To select a current trigger level and slope on output 4 for the datalog:
TRIG:DLOG:CURR 1,(@4)
TRIG:DLOG:CURR:SLOP POS,(@4)
To specify a trigger offset at 25 percent of the duration of the datalog:
SENS:DLOG:OFFS 25
To trigger the datalog measurement: (If the trigger source is BUS, you can also send *TRG or <GET>.)
TRIG:DLOG (@1)
Data Logger Filename
From the front panel:
Select the Filename button to specify a filename in which to save the datalog. Data will be logged to
this filename the next time the Data Logger runs. If you do not specify a filename, the data will be
logged to default.dlog, which is overwritten each time the Data Logger runs.
Enter the filename in the Path\File field. Check Append date and time to filename to include time-
stamp information in the filename.
From the remote interface:
To specify the internal filename in which to save the datalog:
INIT:DLOG "datalog1.dlog"
You can also export the datalog that is presently displayed in the data logger view. To export the
datalog to the specified filename, send:
MMEM:EXP:DLOG "datalog1.csv"
Keysight N6705C User's Guide
163

Publicité

loading