Publicité
Les langues disponibles
Les langues disponibles
Step 4 – Turn on output 1, start the Arb, and log the data:
Press the Data Logger key to return the display to the data logger view:
Press the Output 1 On key to turn on output 1.
l
Press the Run/Stop key to run the data logger. When this key is lit, the data logger is initiated and the
l
output 1 trace is displayed on the screen.
Press the Arb Run/Stop key to start the user-defined Arb and trigger the data logger.
l
The data logger will run for 30 seconds and log the voltage data from output 1. When the data log
completes, you should see the output waveform displayed as follows:
A message will indicate that the logged data has been saved in a file named default.dlog. If you wish
to save the data under a different filename, you must specify the filename before the data logger runs.
Select the Filename button located in the Datalogger Properties dialog to specify a filename.
Step 5 – Use the marker controls to measure the logged data:
Press the Data Logger key to display the marker controls.
Use the marker 1 and Marker 2 knobs to move the markers along the voltage trace. Measurements
l
between the markers are displayed on the bottom of the display.
You can also use the Vertical Volts/Div knob and the Horizontal Time/Div knob to zoom in on any por-
l
tion of the logged data.
From the remote interface:
To program a User-defined voltage waveform of five steps on output 1:
Keysight N6705C User's Guide
4 Using the Measurement Functions
153
Publicité
