Rohde Fusing Serie Notice D'utilisation page 92

6.2.7. Wall mount bracket for ST 411
The control unit bracket can also be mounted on the wall in a safe, easily accessible place next to the kiln. The
embossed arrow on the bracket should point upwards during assembly.
Attention:
Mount the bracket on a suitable, vertical surface that will not get hot. Choose a position where the device is not
exposed to direct heat from the kiln—especially when the lid is open. Use the fastening material that is included in
the scope of delivery.
Note:
If the kiln is equipped with another controller, the bracket is still mounted in the same way. There may be three
mounting holes on the bracket. Therefore, pay attention to the matching holes in the controller mounting plate. Also
pay attention to the alignment of the controller mounting plate so that the controller can be removed upwards.
6.3. Connecting the control unit
6.3.1. General description
The control system is coupled to the kiln via a 14-pin plug-in screw connection with a bayonet lock (CPC-14). The
black socket intended for this is located on the back wall of the kiln.
CPC-14 kiln socket
6.3.2. Establishing the plug connection
Step Description
1 Insert the plug of the control unit into the socket on the kiln.
The plug and socket have a geometric coding. The plug and socket only
2
fit together in one position.
The wide lug on the plug must be at the top in the 12-o'clock position to
3
fit into the wide recess on the socket, also in the 12-o'clock position.
You may have to twist the plug a little until it completely clicks into the
4
socket.
5 Tighten the outer screw ring on the plug clockwise.
CPC-14 controller plug
90 / 298 - EN -
Plug view
*The views is seen from the
front of the contacts, in the
direction of the cable outlet!